Lorem ipsum gravida nibh vel velit auctor aliquetenean sollicitudin, lorem quis bibendum auci elit consequat ipsutis sem nibh id elit duis sed.
Monday - Friday 08:00 - 20:00

Saturday and Sunday - CLOSED

+ 0800 2466 7921
34th Avenue

New York, W2 3XE


Concealed Facade Undercut Anchor System

Design & Application

The aesthetics of the facade face is not compromised by any visible fastening components. There are no limits to creativity. Whether elegant, traditional, modern, or unconventional – any facade designs can be implemented.

The KEIL system drastically reduces the work involved as fewer holes are required and creates economic advantages by generally allowing thinner panel’s to be used, particularly if rare and expensive cladding material is requested.


Safety & Technology

Drilled holes are checked continuously with a monitoring tool to insure that the drilled anchor hole has the correct depth so that the bottom of the anchor can fully expand into the form fit drill hole.

The patented drilling technique carries out the cylindrical and undercut drilling in one step with only one tool.

KEIL anchors are made from high quality A4 stainless steel.


Quick Facts

Damaged cladding material can be easily replaced.

KEIL Anchors can be reused to replace facade panels.

No dirt and rust streaks will appear on the face of the facade, as the attachment is located in the rear.

No limits to your creativity even the boldest facade design can be implemented.

The KEIL technology reduces restrictions on the selection of the ideal ventilated rainscreen facade material on the basis of structural requirements – in particular for ventilated rain screens.

Anchor system reduces work involved as fewer holes are required and creates economic advantages by allowing thinner panels of expensive material to be used.

More than 50 different materials are available, including ceramics, fine stoneware, natural stone, plastics/HPL, fiber cement, glass ceramics, etc.

Tension load is higher compared to dowel or kerf systems.

Drill Machine

Keil Anchor Drill System - Keil Anchor TILE EZE

The drilling of the undercut hole is archived using the KEIL Drilling machines or a CNC machine with KEIL drill bits. Different drill bits for different materials (wet and dry drilling) are available.

Drilling time for a 14.5 mm deep anchor hole, is less than 10 seconds.

Contact TILE EZE to receive more information about KEIL concealed anchoring systems for ventilated facades.